This is how to make a rose using the large flower from the Vintage vogue set which is in the new mini catalogue.
First stamp and cut out three of the large flower.
The first one you cut out one of the petals and the center of the flower.
Roll the petal around a cocktail stick to form the center petal which is layer 1.
Then take the piece you have left which should have 5 petals, place some Tom Bow glue on the petal shown in the picture above bring around the other end and place on top of the glued petal and press together to form a cone this will make layer 4
Take the second flower and cut away two of the petals and the center, place glue on the edges of the two petals to form acone this will make layer 2.
You should be left with four petals, place some Tom Bow glue on the petal shown in the picture above bring around the other end and place on top of the glued petal and press together to form a cone this will make layer 3.
With the third flower cut into the center and just cut out the center, place some Tom Bow glue on the petal shown in the picture above bring around the other end and place on top of the glued petal and press together to form a cone this will make layer 5
Now all you have to do is start with layer 1 and put a small amount of glue around the base and place it inside layer 2 then place a small amount of glue around layer 2 and place layers 1 and 2 into layer 3 and so on until you have all 5 layers done when the rose is dry you can cut of the end to make it sit flat on your card.